Free 186 More Best Homemade Tools eBook:  
Get 2,000+ tool plans, full site access, and more.

User Tag List

Results 1 to 2 of 2

Thread: Compound Rest adjustment adapter

  1. #1
    Supporting Member hemmjo's Avatar
    Join Date
    Feb 2017
    Posts
    2,542
    Thanks
    224
    Thanked 1,446 Times in 820 Posts

    hemmjo's Tools

    Compound Rest adjustment adapter

    The compound rest on my 11” Powermatic/Logan lathe is held in position by two set screws that bear on the center pivot post. This works fine for setting angles when close is good enough. However when more precision is necessary, it is very time consuming and frustrating to get it set correctly. Just when you get the indicator exactly where you want it, as the set screws are tightened, the angle moves.

    I made an adapter that allows more easily setting of angles within a within a couple of 0.0001’s of taper per inch. The inspiration for the design comes from the base an old optical surveyors transit.

    The adapter is just a piece of thin sheet metal that is installed under the compound rest. The most precise work during construction was to bore a hole to match the pivot pin on the compound, then drill an array of holes spaced at 15 degree intervals around that hole. Then drill one hole in the base of the compound to match the holes in the plate. Sketches and photos attached. Compound adjuster.pdf

    The head of an 8-32 x 3/4 socket head machine screw was turned down for a tight fit in the locating holes. The base of the compound was drilled, tapped and counter drilled for the screw, so the head is flush or a little below the plate when it is installed.

    In use, an indicator of choice is set-up to display the desired movement, the compound rest set screws are loosened, but left a little snug, then the adjusting screws are used to move the compound rest while watching the indicator. When the setting is correct, tighten the set screws, then check the indicator.

    John

    186 More Best Homemade Tools eBook

  2. #2
    Content Editor
    Supporting Member
    DIYer's Avatar
    Join Date
    Aug 2013
    Posts
    3,056
    Thanks
    772
    Thanked 1,850 Times in 1,652 Posts


    Thanks hemmjo! We've added your Compound Rest Adjustment Adaptor to our Lathes category,
    as well as to your builder page: hemmjo's Homemade Tools. Your receipt:




    2000 Tool Plans

  3. The Following User Says Thank You to DIYer For This Useful Post:

    NortonDommi (Apr 4, 2017)

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •