Die Filer

[scrdmgl]

Remember C-Bag that in my pages I show a method that I used to make the surface of the CRS plate (3/8" wide x 1/8" Thick x 6" long) rough enough for the epoxy to stick; the file side obviously does not need any preparation. You have to read my article carefully; but anyway I'll remove the plate/file bonded assembly, and take a picture for your benefit and others'.
My advice to you concerning spm (strokes per minute) is that first you put everything together, try it, and then make a decision as to whether to reduce the speed or not. I repeat to you, that this is a "finishing tool" to accomplish fit, finish or both, but not a stock removal tool, that should be done prior to using the filer by other means. I forgot to mention in my article, that to file inside a slot or cavity, all you have to do, is to loosen both screws and remove one to slip the file through the hole.

Jorge