LinkBack URL
About LinkBacks
Hi everyone,
Below is part 3 of a small series I've done about building a Tool Cutter sharpener/grinder
Hi everyone,
Below is part 3 of a small series I've done about building a Tool Cutter sharpener/grinder
12L14 (Jul 31, 2019), asterix (Jul 29, 2021), Bobinwa (Jun 14, 2019), DIYSwede (Jun 17, 2019), emu roo (Jul 20, 2024), Floradawg (Aug 2, 2021), Home-PC (Mar 30, 2023), Jon (Jun 20, 2019), lassab999 (May 10, 2022), nova_robotics (Jul 29, 2021), old_toolmaker (Aug 2, 2021), piper184 (May 2, 2024), Ralphxyz (Jul 20, 2024), RetiredFAE (Jul 30, 2021), Seedtick (Jun 14, 2019), Shanty (Jun 13, 2019), Sleykin (May 10, 2022), that_other_guy (Jun 13, 2019), Tonyg (Jun 14, 2019)
When I spent some time in a repair shop, never quite knew that one of our line boring bars would suit a particular job, when a pump came in. Small shop-made bars haven't room for an adjustment mechanism as MachineNZ points out.
So, a creative member made a clamp on adjuster. It was a Vee-block with a 10-32 screw penetrating through the vee's center, making the indicator perform reliably.
Sincerely,
Toolmaker51
...we'll learn more by wandering than searching...
Any one use one of these end mill sharpening fixtures?
I got one several years ago but it had very little information with it.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote
Bookmarks