Free 173 Best Homemade Tools eBook:  
Become a founding member: 500+ tool plans, full site access, and more.

User Tag List

Results 1 to 4 of 4

Thread: Endmill Sharpener/Grinder - part 3

  1. #1

    Join Date
    Jun 2019
    Posts
    28
    Thanks
    0
    Thanked 72 Times in 17 Posts

    MachineNZ's Tools

    Endmill Sharpener/Grinder - part 3

    Hi everyone,
    Below is part 3 of a small series I've done about building a Tool Cutter sharpener/grinder


    173 Best Homemade Tools eBook

  2. The Following 13 Users Say Thank You to MachineNZ For This Useful Post:

    12L14 (Jul 31, 2019), asterix (Jul 29, 2021), Bobinwa (Jun 14, 2019), DIYSwede (Jun 17, 2019), Floradawg (Aug 2, 2021), Jon (Jun 20, 2019), nova_robotics (Jul 29, 2021), old_toolmaker (Aug 2, 2021), RetiredFAE (Jul 30, 2021), Seedtick (Jun 14, 2019), Shanty (Jun 13, 2019), that_other_guy (Jun 13, 2019), Tonyg (Jun 14, 2019)

  3. #2
    Content Editor
    Supporting Member
    DIYer's Avatar
    Join Date
    Aug 2013
    Posts
    3,078
    Thanks
    654
    Thanked 1,602 Times in 1,436 Posts


    Thanks MachineNZ! We've added your Endmill Sharpener to our Sharpening category,
    as well as to your builder page: MachineNZ's Homemade Tools. Your receipt:




  4. The Following User Says Thank You to DIYer For This Useful Post:

    Toolmaker51 (Jun 16, 2019)

  5. #3
    Supporting Member Toolmaker51's Avatar
    Join Date
    Feb 2016
    Location
    Midwest USA
    Posts
    3,634
    Thanks
    5,588
    Thanked 2,329 Times in 1,442 Posts

    Toolmaker51's Tools
    When I spent some time in a repair shop, never quite knew that one of our line boring bars would suit a particular job, when a pump came in. Small shop-made bars haven't room for an adjustment mechanism as MachineNZ points out.
    So, a creative member made a clamp on adjuster. It was a Vee-block with a 10-32 screw penetrating through the vee's center, making the indicator perform reliably.
    Sincerely,
    Toolmaker51
    ...we'll learn more by wandering than searching...

  6. #4
    meyer77's Avatar
    Join Date
    Feb 2019
    Posts
    106
    Thanks
    0
    Thanked 19 Times in 12 Posts
    Any one use one of these end mill sharpening fixtures?Name:  85-090-001.jpg
Views: 473
Size:  1.4 KB
    I got one several years ago but it had very little information with it.



    173 Best Homemade Tools eBook

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •