Installing Dust Collection Ducting In The Workshop

[The Hobby Machinist NZ]

In this video I install the 6" main trunk ducting for the dust collection system in the workshop.

[DIYer]

Thanks The Hobby Machinist NZ! We've added your Dust Collector Pipe Installation to our Dust Collectors category,
as well as to your builder page: The Hobby Machinist NZ's Homemade Tools. Your receipt:

Dust Collector Pipe Installation by The Hobby Machinist NZ

tags: dust collection

[ductape]

I suggest you run a small, bare copper wire through at least the main run to the metal housing of the blower, then to a ground rod outside in order to reduce the risk of fire or explosion. Air and dust moving through PVC pipe can create enough static charge to make a pretty hefty spark. The solid wire used for doorbells and thermostats works well and is fairly easy to remove the insulation from. Commercial systems use steel piping but that isn't always the best thing for a home shop.

A little late for this, but dry-fitting large plastic pipe goes a little easier if the pipe ends and fittings are first wiped with wire pulling lubricant. It is a gelled alcohol that is fairly slippery and will evaporate after a few hours.

That said, you have a lot of good ideas in that setup. Nice work!