Make circles on a table saw | Homemade Jig

[Karl_H]

Nice build. I have seen similar before and I think Rockler might have a commercial version. You would probably spend more on shipping than your entire costs, though.

What I thought was awesome was the jig you set up to make your knobs! Perfect every time and really ingenious!

As far as not having a center hole - have you considered making a "turn table" slightly undersized from your finished circle, then fastening your blank to the turn table? You could fasten it with some screws into the bottom of your finished circle, if that would be acceptable. I have seen the lathe guys use a "Paper Glue Joint,' but they are using solid wood. I don't know if most modern plywood would work without peeling off the thin final veneer.

Thanks for the post.

Karl

[Christofix]

Karl_H thank you so much for inspiring me with your idea! I will defenetly think about it and try someting with it!

Thank you so much for those kind words about my knob making jig. I have a video about how to build it on my channel, if you are interested go check it out.

Thank you for your reply, Karl_H

Greetings
C