Spindex Mods and Attachment

[rossbotics]

Wonderfull set up. I could see milling hexes on the dumb end of some drill bits I have. I seem to remember the mill in the pictures is a hf mill is that correct? Been looking at them. Also been looking at a stinel sv4 mill. Would like the German made one but the time may not be right. Thanks
Eric

Thanks suther51 for your comment
Yea my mill is one of those red ones from HF, it's a lot of milling machine for the money, I put a 4" riser block under the column, that really extended its capabilities, I don't know much about those two other mills you described, but after owning this mill from HF I would buy another one, like I said it's a lot of mill for the bucks

Thanks
Doug