Free 186 More Best Homemade Tools eBook:  
Get 2,000+ tool plans, full site access, and more.

User Tag List

Results 1 to 2 of 2

Thread: tube holding jig

  1. #1
    Supporting Member
    Join Date
    Aug 2012
    Location
    england
    Posts
    50
    Thanks
    1
    Thanked 60 Times in 46 Posts

    naughtyboy's Tools

    tube holding jig

    below is a tube holding jig i made for bandsaw.
    its made from offcut of 10mm plate left over from another project 2 antenna clamps, and some m8 studding.

    first off i marked position of mounting holes in brackets onto the plate.
    then i drilled and tapped plate m8.
    then i bolted lower bracket down to plate.
    for smaller tubing i use flat side of upper bracket for bigger sizes i flip it over.
    can do 10mm to 40mm tubing on it only limited by length of studs i used.
    tube holding jig-phone-pics-010.jpgtube holding jig-phone-pics-011.jpg

    186 More Best Homemade Tools eBook

  2. The Following User Says Thank You to naughtyboy For This Useful Post:

    kbalch (Aug 12, 2013)

  3. #2
    kbalch's Avatar
    Join Date
    Jun 2012
    Location
    Clermont, FL
    Posts
    5,034
    Thanks
    2,275
    Thanked 531 Times in 383 Posts
    Thanks naughtyboy! I've added your Tube-Holding Jig to our Metalworking category, as well as to your builder page: naughtyboy's Homemade Tools. Your receipt:


    2000 Tool Plans

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •