Unimat Lathe Faceplate and Faceplate Clamps

[alainbiggun]

merci!!! :arc:

j'en ai vu un monté avec ce moteur en France... mais

quoi ??

-j'ai dejà vu des Unimat SL et mod 3 avec moteurs 24v-..

:applaudissements:


i hope doing steel/iron diopter sight and alu bullet mold as LEE model.

[WmRMeyers]

merci!!! :arc:

j'en ai vu un monté avec ce moteur en France... mais

quoi ??

-j'ai dejà vu des Unimat SL et mod 3 avec moteurs 24v-..

:applaudissements:


i hope doing steel/iron diopter sight and alu bullet mold as LEE model.

I hope to do similar work, as well! I have made a sizing die for a Lyman 450 lube and sizing press, as well.
The die and punch on the left side is a factory original, while those on the right side are the ones I made. I have still not gotten to test it to see if I have gotten the size correct. It is supposed to be 0.3160", and is for sizing cast lead bullets for a Mosin-Nagant 91/30 model 7.62x54R rifle with an oversized bore. This was not done on a Unimat, however! Though I believe it would be possible. I did not have the Unimats when I made these parts.

Bill