There have been several stops posted that I have taken notice of, so by chance you are the one that I will ask sense I finally have enough motivation to post a question about them. I do not believe that I have yet seen a post that clearly shows how the stop clamps to the ways of the lathe. Perhaps a picture of the clamp side will be answer enough. Does the clamp or lock nut simply register on the underside of the ways? To be honest I have not owned my lathe long enough to have thought to look at the underside of the ways to see how much of a ledge is there. My lathe is a 12x32 enco of 1990 vintage. Just getting started with it. Finding out that "good condition" can have a more varied meaning than I would have thought. Oh well live and learn. Thanks in advance.
Eric