Free 173 Best Homemade Tools eBook:  

Homemade Carbide Insert Dovetail Cutter


Carbide Insert Dovetail Cutter
Advertisement
BUILDER:
Johan Crous on model-engineer.co.uk
DESCRIPTION:
Homemade carbide insert dovetail cutter machined from round bar stock. Capable of cutting 14mm deep dovetails.
RATING:
(2)
Post a comment
Jan 15, 2017 11:40 PM
Ron 2
Since that is an interrupted cut, doesn't the carbide tend to chip? I've thought of doing that, but as expensive as the carbide was, I didn't think it would hold up.
Read all comments
Rate this build:
CATEGORIES:
TAGS:
LEVEL OF DETAIL (1-5):
2


Newest Forum Posts
  1. Homebuilt East Germany escape aircraft - photo by Frank S on 2019-09-23 13:08:48
  2. Bird wrangler Nina Smith - GIF by Frank S on 2019-09-23 12:59:44
  3. 4-door 1980 Chevrolet Corvette - photos by Frank S on 2019-09-23 12:56:01
  4. Criss Cross by vortexwizard on 2019-09-23 12:49:19
  5. Vintage work crew photos by bruce.desertrat on 2019-09-23 12:11:39
  6. Smoke connects between two fires - GIF by bruce.desertrat on 2019-09-23 12:07:57
  7. Simple welding helmet modification by theeddies on 2019-09-23 12:02:49
  8. underwater truck driving in New Zealand by Hoosiersmoker on 2019-09-23 11:53:46
  9. The man at the controls of the world's largest steam locomotive - photo by Jon on 2019-09-23 11:46:19
  10. Power Drawbar for BP by J.Ramsey on 2019-09-23 11:07:21
DIY Carbide Insert Dovetail Cutter - comment on how to build a Carbide Insert Dovetail Cutter - 1 comments
Ron 2 says:
Jan 15, 2017 11:40 PM
Since that is an interrupted cut, doesn't the carbide tend to chip? I've thought of doing that, but as expensive as the carbide was, I didn't think it would hold up.

Related Homemade Tools:



Signup for our newsletter and get the 173 Best Homemade Tools eBook free!