40 Attachment(s)
Nut Spliter for M6-M8-M10-M12nuts
Sometimes nuts are too much seized on screw or head is so much damaged or too much stuck from rust and they cannot be unscrewed with conventional tools.
With this simple tool, just put the nut you want to loosen into the hole of the Nut Splitter Tool and screw the bolt until the nut breaks.
If needing to be save the bolt in some cases, then do not over tighten to prevent damage to the threads under the nut.
Nut Splitter also is known as Nut Cutter or Nut Cracker.
I made it using a M24 nut
a piece 45mm of rod ø19mm
a piece 25mm which I cut from the tail of an HSS ø10mm drill bit
one bolt MF12x1.25x50mm
two nuts MF12x1.25mm
and a ball bearing ø8mm.
https://youtu.be/1fDw9hzg6z4
Attachment 29484
Attachment 29506 Attachment 29485 Attachment 29486
Attachment 29487 Attachment 29488 Attachment 29489
Attachment 29490 Attachment 29491 Attachment 29492
Attachment 29493 Attachment 29494 Attachment 29495
Attachment 29496 Attachment 29497 Attachment 29498
Attachment 29499 Attachment 29500 Attachment 29501
Attachment 29502 Attachment 29503 Attachment 29504
Attachment 29505 Attachment 29507 Attachment 29508
Attachment 29509 Attachment 29510 Attachment 29511
Attachment 29512 Attachment 29513 Attachment 29514
Attachment 29515 Attachment 29516 Attachment 29517
Attachment 29518 Attachment 29519 Attachment 29520
Attachment 29521 Attachment 29522 Attachment 29523
1 Attachment(s)
I forgot to upload the arrangement of cutting unit
I forgot to upload a sketch with the arrangement;
chisel - ball bearing nest - ball - bolt.
Also is missing and from my YouTube vid.
Attachment 29641
