Jul 14, 2013, 08:24 AM
small parts clamp plate
needed to make up small spacers and was struggling to hold securely so made up clamp plate from some scrap 6mm plate.
started by cutting piece i needed out then marking out holes at 20mm centres.
next drilled a 19mm hole in centre followed by drilling and tapping other holes m6.
now i can clamp small bits to it then clamp plate to drill press table
The Following User Says Thank You to naughtyboy For This Useful Post:
Jul 15, 2013, 08:34 AM
Thanks naughtyboy! I've added your Clamp Plate to our Drilling and Workholding categories, as well as to your builder page: naughtyboy's Homemade Tools. Your receipt:
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts