Uglydog Intro

[Uglydog]

Hope to finish the rear tool post for the Gisholt Ram Turret #5.
I'm copying the much more current Warner Swasey design with the adjustable wedge.
Planning on hardening the wedge.
The rear parting tool will expedite the fab of several replacement axles for some 7.5ton machine skates.
Turn, bore, thread for grease zerks.

Here is a pic of the oven without the front expanded metal safety screen.
The Romex is temporary, as I plan to hard wire her.
You might be able to see the dangling thermo-couple. I also need to figure out how I'm gonna prop her up.
She is a little oven. Only 4x4x9, 120volt, 1phase, 20amps.
The tape measure is only temporary as well.

Daryl
MN