Vise Stand

[jcriss]

here is a simple, angle-able vise stand I put together
3"x4" rectangle tube, scrap plate for the pivot plates, and an old truck wheel

[Paul Jones]

I like the tilting table design and would certainly save my back from all the twisting and turning to get the job done.

[jcriss]

the only thing I think I'm going to change, is to connect/slot the holes for the tilt position. so I dont have to take the bolt the whole way out. and add a grinder hanger or two, onto the rect. tube

[schor]

Nice stand, how about a hitch pin instead of the bolt?

the only thing I think I'm going to change, is to connect/slot the holes for the tilt position. so I dont have to take the bolt the whole way out. and add a grinder hanger or two, onto the rect. tube

[kbalch]

Thanks jcriss! I've added your Vise Stand to our Metalworking category, as well as to your builder page: jcriss' Homemade Tools. Your receipt:

Vise Stand by jcriss

tags: vise, wheel, stand

[DIYer]

That tilting base is a cool feature. I wish I had easy access to that kind of rectangular column, but not in my neck of the woods.