Quote Originally Posted by glens5 View Post
I checked the run-out on the Banggood collets. Some are as much as +/- .010 and the mt2 taper holder +/- .002 so a poor buy at any price.
The spindle run-out is negligible but I had turned the inside mt2 taper at the same time as the rest of the spindle on the lathe so I'd be surprised if there was any.

I don't spend a lot of money gambling, when tools are purchased, and frequently buy used. Hence, my assembly of tooling rivals most any shop I've worked in, including some quite large.
I might call them Danggood.

From what's been heard here of Banggood, can only depend on that being a noise, after handful dropped on a concrete floor...