Quick setup jig using squares magnets and clamps

[Frank S]

I agree Frank.... I have an old 2ft x 3ft roofing square that has been very useful over the years.

I don't know what ever happened to my old tapered framing square since I haven't seen it in many years. I used to have a square that was forged out of Bethlehem steel the back or spine was almost 5/16" thick while the inside was about 1/8" on it was the usual inscribing's for Hip, Val, riser, deg. of slope, and circle segment info on 1 side the other had rafter bracing cut angles and lengths per roof pitch angle. It was the busiest square I had ever seen with regards to the info on it.
I don't have any idea where I got it probably in some auction and I suspect some sticky fingered worker relieved it from my kit